A consultant recently told me that his client is planning to produce parts under NASM22529. He asked for advice about the process for showing compliance to get a PMA.
NASM22529 is an AIA/ NAS standard. It replaced a milspec of the same number that was retired in 1996. As an AIA (NAS) specification, it is recognized as the sort of industry specification that supports ‘standard parts’ under the FAA’s interpretation of the term.
Standards parts can be manufactured and sold without a PMA. The regulatory authority for this can be found at 14 C.F.R. § 21.9(a)(3). Therefore a PMA is not necessary in order to produce standard parts intended to be consumed in civil aviation.
While it is not necessary to seek FAA approval to manufacture a standard part,it is nonetheless possible to get a PMA for a standard part, and in some cases (like fasteners) it can also be possible to obtain a TSOA for a standard part.
There are a number of reasons why someone might seek to obtain FAA approval for a standard part. This sort of FAA approval can be valuable for marketing purposes.
If you seek FAA approval for a part, then the design of the part must be shown to meet the appropriate FAA standards, and the production quality assurance system must be developed to meet FAA requirements.
The same consultant also asked whether AS9100 certification satisfies all or most of the PMA requirements? The AS9100 series of specifications were specifically designed to support compliance to aviation regulatory standards, but compliance with AS9100 should not be confused with compliance to FAA regulations. The answer to this question can depend on the implementation of the AS9100 system.
AS9100 will typically satisfy requirements under 14 C.F.R. § 21.137, as well as certain other requirements, but it may does not satisfy all FAA approval requirements (A well-developed AS9100 system can be developed to provide management assurance of compliance with all of the relevant FAA requirements but it can also be developed to omit some of them).
The design side of the manufacturing process is a process that is particularly susceptible to a finding that the AS9100 system is not adequate, alone, to ensure compliance to FAA regulations.
Looking to learn more about PMAs? You may want to consider attending the MARPA Conference in Orlando on October 25-26, 2017. The FAA has confirmed that they will be teaching a “PMA 101” workshop as part of the Conference. You can find out more at http://pmaparts.org/annualconference/about.shtml